Convection Microwave Not Heating in Convection Mode
Microwave mode works but convection stays cold? The settings to rule out first, and the four parts that usually cause it: heater, fan, sensor or relay.

Quick answer: if your oven still heats food in microwave mode but stays cold or barely warms in convection mode, one of the convection parts has failed. Usually it is the convection heater element, the convection fan motor, the temperature sensor, or the relay on the control board that switches the heater on. Before booking a repair, rule out settings: check that convection mode (not microwave, grill or combination) is selected, that the preheat finished, and that you are using the rack and utensils the manual specifies.
Send a photo of the microwave and its model sticker. The price is agreed before any work starts.
How convection mode works
A convection microwave is really two ovens in one box. In microwave mode, the magnetron heats the food directly. In convection mode, a separate heater element warms the air, and a fan blows that hot air around the cavity, like a small electric oven. A temperature sensor tells the control board when the set temperature is reached, and a relay on the board switches the heater on and off.
Because these parts are separate from the magnetron, one side can fail while the other works perfectly. That is why “microwave fine, convection dead” is such a common fault, and why it does not mean the whole oven is failing.
Check these first
- The right mode. Convection, grill and combination modes look similar on many control panels. Combination uses microwave power as well, and grill uses the top heater only. Make sure you have selected convection and set a temperature.
- The preheat. Most recipes assume a preheated oven. Wait for the oven to signal that preheat is complete before putting food in. Skipping it makes the oven seem weak.
- The rack and utensils. Use the rack the manual specifies for convection, and leave space around the dish so air can move. Metal tins are normally fine in convection-only mode but not in microwave or combination mode, so follow your manual.
- The door. Make sure it is fully shut. A door that is not latched stops every mode.
- The grill. Try grill mode for a few minutes. If the grill heats but convection does not, the convection heater, fan or sensor is the likely culprit. If both are dead, a shared relay or board fault is more likely.
Preheating an empty oven in convection-only mode is normal, and it is what the manuals tell you to do. Running an empty oven in microwave or combination mode is not, because the magnetron absorbs its own energy and can be damaged.
What usually fails
| What you notice | Likely cause |
|---|---|
| No heat at all in convection; fan turns | Convection heater element, its thermal cut-out, or the relay |
| Heats slowly or unevenly; fan not turning | Convection fan motor |
| Heats, then stops or shows an error | Temperature sensor or its wiring |
| Grill and convection both dead, microwave fine | Relay or control board |
| MCB trips only in convection mode | Heater element shorting to earth |
| Burning smell when convection runs | Grease or food residue on the heater, or a scorched connection |
The heater element
Like any heating element, it can burn out, especially if grease builds up on it or the oven is often used at its highest temperature. A burnt-out element gives no heat at all, while the fan and light still work.
The convection fan
If the heater works but the fan does not, the air near the heater gets hot while the rest of the cavity stays cool. Food browns on one side or cooks very slowly. A seized fan sometimes makes a hum or grinding noise first.
The temperature sensor
If the sensor misreads, the board may think the oven is already hot and switch the heater off, or it may show an error code and stop. Check your manual for what the code means on your model.
The relay or board
The heater is switched by a relay on the control board. If the relay fails, the heater gets no power even though it is fine. Board repair sometimes needs bench work and a second visit, and you are told before that happens.
Safety first: even if the fault is “only” the convection heater, all of these parts sit inside the casing next to the high-voltage section, and the capacitor there can hold a lethal charge after the oven is unplugged. Do not open the casing. If the oven trips the MCB in convection mode, sparks, or gives off a strong burning smell, unplug it and stop using it.
Is it worth repairing?
Usually, yes. Convection ovens cost more to replace than solo models, and the heater, fan and sensor are individual parts rather than whole assemblies. The answer changes if the cavity has rusted through, the door or hinge is damaged, or several unrelated faults have appeared at once. Our guide to microwave repair or replacement covers the decision in more detail.
If the opposite is happening, with convection working but food staying cold in microwave mode, the fault is on the high-voltage side. That is covered in why a microwave stops heating.
Habits that protect the convection side
- Clean grease off the cavity and heater guard once the oven has cooled. Baked-on grease is what burns and smells.
- Do not block the vents. Convection runs hot for long periods, and the electronics need the cooling air.
- Follow the manual on utensils and foil. Metal and foil rules differ between convection and microwave modes, and foil touching the cavity walls can spark in combination mode.
- Let moisture out. After baking or roasting, leave the door open for a few minutes once the oven is off. In Kolkata’s humid months, trapped moisture speeds up rust in the cavity.
- Switch off at the socket during storms and long power cuts. Voltage spikes when the power returns can damage the control board.
When to call a technician: if convection still will not heat after the checks above, if the fan has stopped, or if the oven shows an error code in convection mode. Brands such as IFB and LG both sell convection models, and we repair those and most other brands through our independent microwave repair service in Kolkata. We are not connected to any manufacturer. If your oven is under warranty, contact the brand’s own service centre first.
Frequently asked questions
Why is my convection microwave not heating in convection mode?
If microwave mode still works, one of the convection parts has usually failed: the heater element, the convection fan motor, the temperature sensor or the relay on the control board that switches the heater on. First check that convection, not microwave, grill or combination, is selected, that preheat finished, and that the door is fully shut.
Why does my microwave work but the convection does not?
Microwave mode uses the magnetron, while convection mode uses a separate heater element, fan and temperature sensor. Because the two systems are independent, one can fail while the other keeps working. It is a common fault and does not mean the whole oven is failing. The convection parts can usually be replaced individually.
Can I use metal utensils in convection mode?
In convection-only mode, metal tins and the supplied rack are normally fine, because no microwave energy is used. In microwave or combination mode, metal can spark and damage the oven. The rules vary by model, so check your manual, and never let foil touch the cavity walls.
Why does my convection microwave trip the MCB?
If the MCB trips only when convection mode starts, the convection heater element may be shorting to earth. Unplug the oven and stop using it until it has been checked. Do not open the casing to look, because the high-voltage capacitor inside can hold a dangerous charge even after the oven is unplugged.
Is it worth repairing the convection part of a microwave?
Usually, yes. Convection ovens cost more to replace than basic solo models, and the heater, fan and sensor are individual parts. Replacement makes more sense if the cavity has rusted through, the door or hinge is damaged, or several unrelated faults have appeared at once.
Published by
Geyser & Microwave Service — an independent geyser and microwave repair service working in homes across Kolkata. Questions about this guide, or a fault that is not covered here? Get in touch.
Book a geyser or microwave repair
Tell us the appliance, brand and the problem, and we will arrange a technician visit in your area of Kolkata.
+91 82740 66348More repair guides
Racold vs Venus Geyser – Which Lasts Longer?
A fair look at Racold and Venus storage geysers: what each maker says about its tanks and warranties, and the three things that decide…
What Size Geyser Do You Need? (10, 15, 25 Litre)
10, 15 or 25 litres? How to size a geyser by how many people need hot water in the same hour, bucket or shower,…
Geyser Not Turning On? 7 Checks Before You Call
No light, no heat, no sign of life? Seven safe checks to rule out a switch, MCB, setting or supply problem before you book…